Users Guide

Default 32768
Command Mode CONFIGURATION
Usage
Information
Each device that runs LACP has an LACP system priority value. LACP uses the system priority with the
MAC address to form the system ID and also during negotiation with other systems. The system ID is
unique for each device. The no version of this command resets the system priority to the default value.
Example
OS10(config)# lacp system-priority 32768
Supported
Releases
10.2.0E or later
show lacp counter
Displays information about LACP statistics.
Syntax
show lacp counter [interface port-channel channel-number]
Parameters
● interface port channel — (Optional) Enter the interface port-channel.
● channel-number — (Optional) Enter the LACP channel group number (1 to 128).
Default Not configured
Command Mode EXEC
Usage
Information
If you do not enter the channel-number parameter, all channel groups display.
Example
OS10# show lacp counter interface port-channel 11
LACPDUs Port Marker Marker Response LACPDUs
Sent Recv Sent Recv Sent Recv Err Pkts
---------------------------------------------------------------------------
ethernet1/1/1:1 0 0 0 0 7950 7948 0
ethernet1/1/2:1 0 0 0 0 7950 7948 0
ethernet1/1/3:1 0 0 0 0 7950 7948 0
ethernet1/1/4:1 0 0 0 0 7950 7948 0
ethernet1/1/5:1 0 0 0 0 7950 7948 0
ethernet1/1/6:1 0 0 0 0 7950 7948 0
ethernet1/1/7:1 0 0 0 0 7950 7948 0
ethernet1/1/8:1 0 0 0 0 7950 7948 0
ethernet1/1/9:1 0 0 0 0 7967 7961 0
ethernet1/1/10:1 0 0 0 0 7967 7961 0
ethernet1/1/11:1 0 0
Supported
Releases
10.2.0E or later
show lacp interface
Displays information about specific LACP interfaces.
Syntax
show lacp interface ethernet node/slot/port
Parameters node/slot/port — Enter the interface information.
Default Not configured
Command Mode EXEC
Usage
Information
The LACP_activity field displays if you configure the link in Active or Passive port channel mode. The Port
Identifier field displays the port priority as part of the information including the port number. For example,
Port Identifier=0x8000,0x101, where the port priority value is 0x8000 and the port number
value is 0x101.
558 Layer 2