Users Guide

Supported
Releases
10.4.0E(R1) or later
fcoe delay fcf-adv
Delay the Multicast Discovery Advertisement from FCFs to be sent to Enodes.
Syntax
fcoe delay fcf-adv timeout
Parameters
timeout - Timeout range specified in seconds. Range is 1 to 30 seconds.
Default Not configured
Command Mode Global config
Usage
Information
Time to wait after the first FCF in the vFabric connects to the NPG switch to send the Multicast
discovery Advertisement. This command is supported in NPG mode.
Example
OS10(config)# fcoe delay fcf-adv 16
Supported
Releases
10.5.2.0 or later. In previous releases, the command is not available in full switch mode. From this release,
the command is available both in full switch mode and fabric mode.
fcoe-pinned-port
Marks a port as a pinned port in the port-channel. This configuration is supported on FSB, Ethernet LAG in NPG, and F_Port
mode. It is not supported on a VLTi LAG.
Syntax
fcoe-pinned-port
Parameters node/slot/port[:subport]—Enter the interface type details.
Defaults Disabled
Command Mode Port-channel INTERFACE
Usage
Information
You can configure only single port per port-channel. If the port is not configured properly, or if the pinned
port goes down, the other ports in the port-channel are not used even if the ports have valid path to
server. The no version of this command removes the pinned port configuration.
Example
OS10(conf-if-eth-1/1/9)# channel-member 10
OS10(conf-if-eth-1/1/9)# fcoe-pinned-port
Warning: Any existing FCoE session in port-channel will get cleared. Do
you want to continue(yes/no)?yes
Supported
Releases
10.4.2.0 or later
fcoe max-sessions-per-enodemac
Configures the maximum number of sessions allowed for an ENode.
Syntax
fcoe max-sessions-per-enodemac max-session-number
Parameters max-session-number — Enter the maximum number of sessions to be allowed, from 1 to 64.
Defaults 32
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the number of sessions to the default value.
512 Fibre Channel