Users Guide

==================================================================
set hba1 21:00:00:24:ff:7b:f5:c8
10:00:00:90:fa:b8:22:19
21:00:00:24:ff:7f:ce:ee
21:00:00:24:ff:7f:ce:ef
hba2 20:01:00:0e:1e:e8:e4:99
50:00:d3:10:00:ec:f9:1b
50:00:d3:10:00:ec:f9:05
50:00:d3:10:00:ec:f9:1f
20:35:78:2b:cb:6f:65:57
Supported
Releases
10.3.1E or later
zone default-zone permit
Enables access between all logged-in FC nodes of the vfabric in the absence of an active zoneset configuration.
Syntax
zone default-zone permit
Parameters None
Defaults Not configured
Command Mode Vfabric CONFIGURATION
Usage
Information
A default zone advertises a maximum of 255 members in the registered state change notification (RSCN)
message. The no version of this command disables access between the FC nodes in the absence of an
active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported
Releases
10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not configured
Command Mode vfabric CONFIGURATION
Usage
Information
After you disable an active zoneset, the zone default-zone permit command configuration takes
effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC
nodes of the vfabric. The no version of this command deactivates the zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported
Releases
10.3.1E or later
NPG commands
The following commands are supported on NPG mode:
496
Fibre Channel