Users Guide

Example
OS10# show boot
Current system image information:
===================================
Type Boot Type Active Standby Next-Boot
------------------------------------------------------------------------------------
---
Node-id 1 Flash Boot [A] 10.5.0.4 [B] 10.5.1.0 [B] standby
Example (Detail)
OS10# show boot detail
Current system image information detail:
==========================================
Type: Node-id 1
Boot Type: Flash Boot
Active Partition: A
Active SW Version: 10.5.0.4
Active SW Build Version: 10.5.0.4.650
Active Kernel Version: Linux 4.9.189
Active Build Date/Time: 2020-02-11T11:13:08Z
Standby Partition: B
Standby SW Version: 10.5.1.0
Standby SW Build Version: 10.5.1.0.123
Standby Build Date/Time: 2020-02-12T02:34:02Z
Next-Boot: standby[B]
Supported
Releases
10.2.0E or later
show image firmware
Displays any pending firmware upgrades and the status of past firmware upgrades.
Syntax
show image firmware
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
If you install an OS10 firmware file, the firmware upgrade is stored as a pending installation until you
reload the switch. To view the contents of the firmware upgrade, use the show image firmware
command. No entries are displayed in the show command output if there are no pending or past firmware
upgrades available.
Example
OS10# show image firmware
Pending Firmware Upgrade(s)
====================================
# Name
Version Date
--- ----------------------------------------------------
--------------- ---------------------
Past Firmware Upgrade(s)
====================================
Name
Version Result
--------------------------------------------------------- -------------
----------------
onie-firmware-x86_64-dellemc_s5200_c3538-r0.3.40.5.1-6.
3.40.5.1-6 Success
onie-updater
3.40.1.1-5 Fail
onie-updater-x86_64-dellemc_s5200_c3538-r0.3.40.1.1-6
3.40.1.1-6 Fail
Getting Started with Dell EMC SmartFabric OS10 49