Users Guide

Default Disabled (off)
Command Mode INTERFACE
Usage
Information
The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# flowcontrol transmit on
Supported
Releases
10.3.0E or later
hardware deep-buffer-mode
Configures Deep Buffer mode.
Syntax
hardware deep-buffer-mode
Parameters None
Defaults Disabled
Command Modes CONFIGURATION
Usage
Information
Applicable only for the S4200-ON series switches. Deep Buffer mode configuration takes effect only after
you save it in the startup configuration and reboot the switch. The no version of this command disables
Deep Buffer mode.
Example
OS10(config)# hardware deep-buffer-mode
Supported
Releases
10.4.3.0 or later
match
Configures match criteria for the QoS policy.
Syntax
match {cos cos-number | ip [access-group name name | dscp dscp-value [ecn
ecn-value] | precedence value] | ip-any [dscp dscp-value [ecn ecn-value] |
precedence value] | ipv6 [access-group name name | dscp dscp-value [ecn
ecn-value] | precedence value] | mac access-group acl-name | not [cos | ip
| ip-any | ipv6] | vlan vlan-id | protocol-or-application-name}
Parameters
● cos cos—number — Enter a queue number for the CoS match criteria, from 0 to 7.
● ip — Enter the IPv4 match criteria.
● access-group name name — (Optional) Enter the IPv4 access-group name.
● dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
● ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
● precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from
0 to 7.
● ip-any — Enter the IPv4 or IPv6 match criteria.
● dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
● ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
● precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from
0 to 7.
● ipv6 — Enter the IPv6 match criteria.
● access-group name name — (Optional) Enter the IPv6 access-group name.
● dscp dscp-value — (Optional) Configure a DSCP value for L3 DSCP match criteria, from 0 to 63.
● ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
1582 Quality of service