Users Guide

Usage
information
The virtual network operates as a L2 bridging domain. To add a VXLAN to the virtual network, use the
vxlan-vni command. The no version of this command removes the configured virtual network.
Example
OS10(config)# virtual-network 1000
OS10(config-vn)#
Supported
releases
10.4.2.0 or later
virtual-network untagged-vlan
Configures a dedicated VLAN for internal use to transmit untagged traffic on member ports in virtual networks on the switch.
Syntax
virtual-network untagged-vlan vlan-id
Parameters
id
Enter the reserved untagged VLAN ID, from 1 to 4093.
Default Not configured
Command mode CONFIGURATION
Usage
information
The untagged VLAN ID is used internally for all untagged member interfaces that belong to virtual
networks. You cannot use the reserved untagged VLAN ID for a simple VLAN bridge or for tagged traffic
on member interfaces of virtual networks. The no version of this command removes the configured value.
Example
OS10(config)# virtual-network untagged-vlan 10
Supported
releases
10.4.2.0 or later
vxlan-vni
Assigns a VXLAN ID to a virtual network.
Syntax
vxlan-vni vni
Parameters
vni
Enter the VXLAN ID for a virtual network, from 1 to 16,777,215.
Default Not configured
Command mode VIRTUAL-NETWORK
Usage
information
This command associates a VXLAN ID number with a virtual network. The no version of this command
removes the configured ID.
Example
OS10(conf-vn-100)# vxlan-vni 100
OS10(config-vn-vxlan-vni)#
Supported
releases
10.4.2.0 or later
VXLAN MAC commands
clear mac address-table dynamic nve remote-vtep
Clears all MAC addresses learned from a remote VTEP.
Syntax
clear mac address-table dynamic nve remote-vtep ip-address
VXLAN 1159