Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4112F-ON/S4112T-ON

1101

CR1(conf-vlt-128)# backup destination 10.222.208.160

CR1(conf-vlt-128)# discovery-interface ethernet1/1/27:2

CR1(conf-vlt-128)# peer-routing

CR1(conf-vlt-128)# primary-priority 1

CR1(conf-vlt-128)# vlt-mac 9a:00:00:aa:aa:aa

3. Configure a port channel interface towards AG1 and AG2.

CR1(config)# interface port-channel 11

CR1(config)# interface ethernet 1/1/1:1

CR1(conf-if-eth1/1/1:1)# channel-group 11 mode active

CR1(config)# interface ethernet 1/1/9:1

CR1(conf-if-eth1/1/9:1)# channel-group 11 mode active

CR1(config)# interface port-channel 11

CR1(conf-if-po-11)# vlt-port-channel 11

4. Configure a port channel interface towards AG3.

CR1(config)# interface port-channel 21

CR1(config)# interface ethernet 1/1/25:1

CR1(conf-if-eth1/1/25:1)# channel-group 21 mode active

5. Configure a port channel interface towards AG4.

CR1(config)# interface port-channel 31

CR1(config)# interface ethernet 1/1/17:1

CR1(conf-if-eth1/1/17:1)# channel-group 31 mode active

6. Configure a Loopback interface and enable PIM-sparse mode.

CR1(config)# interface loopback 1

CR1(conf-if-lo-1)# ip address 10.1.100.5/32

CR1(conf-if-lo-1)# ip pim sparse-mode

7. Enable multicast routing on the default VRF.

CR1(config)# ip multicast-routing

8. Enable BSR.

CR1(config)# ip pim bsr-candidate loopback1 hash-mask-len 31 priority 199

9. Enable the RP candidate.

CR1(config)# ip pim rp-candidate loopback1 priority 100 acl mcast_acl

10. Configure an access-list for RP mapping.

CR1(config)# ip access-list mcast_acl

CR1(config-ipv4-acl)# permit ip any 225.0.0.0/8

11. Configure OSPF for unicast routing.

CR1(config)# router ospf 1

CR1(config-router-ospf-1)# log-adjacency-changes

CR1(config-router-ospf-1)# redistribute connected

CR1(config-router-ospf-1)# router-id 10.1.100.5

12. Configure the IP address, OSPF process, and PIM-SM on the VLANs.

● VLAN 100 towards CR2

CR1(config)# interface vlan 100

CR1(conf-if-vl-100)# ip address 10.1.1.5/24

CR1(conf-if-vl-100)# ip ospf 1 area 0.0.0.0

CR1(conf-if-vl-100)# ip pim sparse-mode

CR1(conf-if-vl-100)# ip pim dr-priority 1

1104

Multicast