Connectivity Guide

May 23 17:10:08 OS10 base_nas: [NETLINK:NH-
EVENT]:ds_api_linux_neigh.c:nl_to_nei
--More--
Supported Releases 10.2.0E or later
Log into OS10 device
Linux shell access is available for troubleshooting and diagnostic purposes only. Use linuxadmin for both the default user name and
password. For security reasons, you must change the default linuxadmin password during the rst login from the Linux shell. Use the
username CLI command to change the password. Enter the write memory command for the system to save the new password for
future logins.
CAUTION: Changing the system state from the Linux shell can result in undesired and unpredictable system behavior. Only use
Linux shell commands to display system state and variables, or as instructed by Dell EMC Support.
OS10 login: linuxadmin
Password: linuxadmin >> only for rst-time login
You are required to change your password immediately (root enforced)
Changing password for linuxadmin.
(current) UNIX password: linuxadmin
Enter new UNIX password: enter a new password
Retype new UNIX password: re-enter the new password
Linux OS10 3.16.7-ckt20 #1 SMP Debian 3.16.7-ckt20-1+deb8u4 (2017-05-01) x86_64
The programs included with the Debian GNU/Linux system are free software;
the exact distribution terms for each program are described in the
individual files in /usr/share/doc/*/copyright.
Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent
permitted by applicable law.
-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-
-* Dell EMC Network Operating System (OS10) *-
-* *-
-* Copyright (c) 1999-2017 by Dell Inc. All Rights Reserved. *-
-* *-
-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-
This product is protected by U.S. and international copyright and
intellectual property laws. Dell EMC and the Dell EMC logo are
trademarks of Dell Inc. in the United States and/or other
jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
linuxadmin@OS10:~$
To log in to OS10 and access the command-line interface, enter su — admin at the Linux shell prompt, then admin as the password.
linuxadmin@OS10:~$ su - admin
Password: admin
OS10#
Frequently asked questions
This section contains answers to frequently asked questions for ONIE-enabled devices.
• Installation contains information about how to enter ONIE: Install mode after a reboot, nd information about your specic switch, how
to log into the OS10 shell, and so on.
• Hardware contains information about how to view default console settings, how to view hardware alarms and events, how to view LED
status, and so on.
978
Troubleshoot OS10