Connectivity Guide

delay-restore
Congures a time interval to delay VLT ports bring up after reload or peer-link restoration between the VLT peer switches.
Syntax
delay-restore seconds
Parameters seconds — Enter a delay time, in seconds, to delay bringing up VLT ports after the VLTi device is reloaded, from 1
to 1200.
Default 90 seconds
Command Mode VLT-DOMAIN
Usage Information Use this command to delay the system from bringing up the VLT port for a brief period to allow L3 routing
protocols to converge. If the peer VLT device was up at the time the VLTi link failed, use this command after you
reload a VLT device. The no version of this command resets the delay time to the default value.
Example
OS10(conf-vlt-1)# delay-restore 100
Supported Releases 10.3.0E or later
discovery-interface
Congures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers.
Syntax
discovery-interface {ethernet node/slot/port[:subport]}
Parameters ethernet — Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of
interfaces separated by hyphens.
Default None
Command Mode VLT-DOMAIN
Usage Information The VLT node discovery service auto-LAGs the discovery ports and creates VLTi interfaces. The no version of this
command disables the discovery-interface conguration.
Example
OS10(config)# vlt-domain 1
OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15
Example (range)
OS10(config)# vlt-domain 2
OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12
Supported Releases 10.2.0E or later
peer-routing
Enables or disables L3 routing to peers.
Syntax
peer-routing
Parameters None
Default Disabled
Command Mode VLT-DOMAIN
848 Virtual Link Trunking