Connectivity Guide

Example
batch /home/admin/b.cmd
Jun 26 18:29:12 OS10 dn_l3_core_services[723]: Node.1-Unit.1:PRI:notice
[os10:trap],
%Dell EMC (OS10) %log-notice:IP_ADDRESS_ADD: IP Address add is successful.
IP 172.17.4.1/24 in VRF:default added successfully
Supported Releases 10.2.0E or later
boot
Congures which OS10 image to use the next time the system boots up.
Syntax
boot system [active | standby]
Parameters
• active — Reset the running partition as the next boot partition.
• standby — Set the standby partition as the next boot partition.
Default Not congured
Command Mode EXEC
Usage Information Use this command to congure the location of the OS10 image used to reload the software at boot time. Use the
show boot command to view the congured next boot image. This command is applied immediately.
Example
OS10# boot system standby
Supported Releases 10.2.0E or later
commit
Commits changes in the candidate conguration to the running conguration.
Syntax
commit
Parameters None
Default Not congured
Command Mode EXEC
Usage Information Use this command to save changes to the running conguration. Use the do commit command to save changes
in CONFIGURATION mode.
Example
OS10# commit
Example
(conguration)
OS10(config)# do commit
Supported Releases 10.2.0E or later
Getting Started 59