Connectivity Guide

interface ethernet1/1/8
lacp port-priority 4096
lacp rate fast
no shutdown
!
...
Interfaces
Create a LAG and then add LAG member interfaces. By default, all interfaces are in no shutdown and switchport modes.
1 Create a LAG in CONFIGURATION mode.
interface port-channel port-channel number
2 Enter INTERFACE mode.
interface ethernet node/slot/port[:subport]
3 Set the channel group mode to Active in INTERFACE mode.
channel-group number mode active
Congure dynamic LAG interfaces
OS10(config)# interface port-channel 10
OS10(conf-if-po-10)# exit
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# no switchport
OS10(conf-if-eth1/1/10)# channel-group 10 mode active
OS10(conf-if-eth1/1/10)# exit
OS10(config)# interface ethernet 1/1/11
OS10(conf-if-eth1/1/11)# no switchport
OS10(conf-if-eth1/1/11)# channel-group 10 mode active
Rates
Protocol data units (PDUs) are exchanged between port-channel (LAG) interfaces to maintain LACP sessions. PDUs are transmitted at
either a slow or fast transmission rate, depending on the LACP timeout value. The timeout value is the amount of time that a LAG interface
waits for a PDU from the remote system before bringing the LACP session down.
By default, the LACP rate is normal (long timeout). If you congure a fast LACP rate, a short timeout sets.
• Set the LACP rate in CONFIGURATION mode.
lacp rate [fast | normal]
Congure LACP timeout
OS10(conf-if-eth1/1/29)# lacp rate fast
View port status
OS10# show lacp port-channel
Port-channel 20 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address f8:b1:56:00:02:33
Partner System ID: Priority 4096, Address 10:11:22:22:33:33
Actor Admin Key 20, Oper Key 20, Partner Oper Key 10
LACP LAG ID 20 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC,
I - Collection enabled, J - Collection disabled, K - Distribution enabled,
L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
O - Receiver is in expired state, P - Receiver is not in expired state
Port ethernet1/1/14 is Enabled, LACP is enabled and mode is lacp
176
Layer 2