Connectivity Guide

• To congure breakout interfaces on a unied port, use the mode {Eth | FC} command in Port-Group
Conguration mode.
Example
OS10(config)# interface breakout 1/1/41 map 10g-4x
Supported Releases 10.2.2E or later
interface ethernet
Congures a physical Ethernet interface.
Syntax
interface ethernet node/slot/port:subport
Parameters node/slot/port:subport — Enter the Ethernet interface information.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface ethernet 1/1/10:1
OS10(conf-if-eth1/1/10:1)#
Supported Releases 10.2.0E or later
interface loopback
Congures a Loopback interface.
Syntax
interface loopback id
Parameters id — Enter the Loopback interface ID number, from 0 to 16383.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the Loopback interface.
Example
OS10(config)# interface loopback 100
OS10(conf-if-lo-100)#
Supported Releases 10.2.0E or later
interface mgmt
Congures the Management port.
Syntax
interface mgmt node/slot/port
Parameters node/slot/port — Enter the physical port interface information for the Management interface.
Default Enabled
Command Mode CONFIGURATION
Interfaces 111