Users Guide

Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported
Releases
10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf [vrf vrf-name] neighbor
Parameters
● vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to display a list of
OSPFv3 neighbors in that VRF.
Default Not configured
Command Mode EXEC
Usage
Information
● Neighbor ID—Displays the neighbor router ID.
● Pri—Displays the priority assigned neighbor.
● State—Displays the OSPF state of the neighbor.
● Dead Time—Displays the expected time until the system declares the neighbor dead.
● Interface ID—Displays the neighbor interface ID
● Interface—Displays the interface type, node/slot/port or number information.
Example
OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor
Neighbor ID Pri State Dead Time Interface ID Interface
-------------------------------------------------------------------
2.2.2.2 1 Full/DR 00:00:30 5 ethernet1/1/1
Supported
Releases
10.3.0E or later
show ipv6 ospf statistics
Displays OSPFv3 traffic statistics.
Syntax
show ipv6 ospf [instance-number] statistics [interface interface]
Parameters
● instance-number — (Optional) Enter an OSPFv3 instance number, from 1 to 65535.
● interface interface — (Optional) Enter the interface information:
○ ethernet node/slot/port[:subport] — Enter an Ethernet port interface.
○ port-channel number — Enter the port-channel interface number, from 1 to 128.
○ vlan vlan-id — Enter the VLAN ID number, from 1 to 4093.
Default Not configured
Command Mode EXEC
Usage
Information
This command displays OSPFv3 traffic statistics for a specified instance or interface, or for all OSPFv3
instances and interfaces.
Example
OS10# show ipv6 ospf interface ethernet 1/1/1
Interface ethernet1/1/1
Receive Statistics
rx-invalid 0 rx-invalid-bytes 0
rx-hello 0 rx-hello-bytes 0
rx-db-des 0 rx-db-des-bytes 0
rx-ls-req 0 rx-ls-req-bytes 0
rx-ls-upd 0 rx-ls-upd-bytes 0
Layer 3 793