Users Guide

Supported
Releases
10.2.0E or later
source
Configures a source for port monitoring. The monitoring session can be: local, RPM, or ERPM.
Syntax
source interface interface-type {both | rx | tx}
Parameters
● interface-type—Enter the interface type:
○ ethernet node/slot/port[:subport]—Enter the Ethernet interface information as the
monitored source.
○ port-channel id-number—Enter the port-channel interface number as the monitored
source, from 1 to 128.
○ vlan vlan-id—Enter the VLAN identifier as the monitored source, from 1 to 4093.
● both—Monitor both receiving and transmitting packets. This option is not supported on VLAN
interfaces.
● rx—Monitor only received packets.
● tx—Monitor only transmitted packets. This option is not supported on VLAN interfaces.
Default Not configured
Command Mode MONITOR-SESSION
Usage
Information
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)# source interface ethernet 1/1/7 rx
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)# source interface ethernet 1/1/10 rx
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)# source interface ethernet 1/1/5 rx
Supported
Releases
10.2.0E or later
source-ip
Configures the source, destination, and protocol type of the monitored port for an ERPM monitoring session.
Syntax
source-ip source ip-address destination-ip destination ip-address [gre-
protocol protocol-value]
Parameters
● source ip-address—Enter the source IP address.
● destination ip-address—Enter the destination IP address.
● protocol-value—Enter the GRE protocol value, from 1 to 65535, default: 35006.
Default Not configured
Command Mode MONITOR-SESSION
Usage
Information
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S). Also supported in SmartFabric Services mode on the
MX9116n and MX5108n from the Dell EMC SmartFabric OS release 10.5.1.
566 Layer 2