Users Guide

Fabric Type FPORT
Fabric Id 10
VlanId 1001
FC-MAP 0EFC00
Config-State ACTIVE
Oper-State UP
==========================================
Switch Config Parameters
==========================================
Domain ID 4
==========================================
Switch Zoning Parameters
==========================================
Default Zone Mode: Deny
Active ZoneSet: zoneset5
=========================================
Members
fibrechannel1/1/25
port-channel10(Eth 1/1/9)
Supported
Releases
10.3.1E or later
vfabric
Configures a vfabric.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
Enable the F_Port or NPG feature before configuring a vfabric. You can configure only one vfabric in
F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC
map. Do not use spanned VLAN as vfabric VLAN.
The no version of this command removes the vfabric. You can remove a vfabric only when it is not
applied on any interface.
Supported on the MX9116n switch in Full Switch mode starting in release 10.4.1.0. Also supported in
SmartFabric mode starting in release 10.5.0.1.
Example
OS10(config)# vfabric 100
Supported
Releases
10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an Ethernet or FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes the vfabric from the interface.
420 Fibre Channel