Users Guide

Supported
Releases
10.5.1.0 or later
show ptp time-properties
Displays information about the time scale.
Syntax
show ptp time-properties
Parameters None
Defaults None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
This command is not applicable for transparent clocks.
Example
OS10# show ptp time-properties
Current UTC Offset Valid : False
Current UTC Offset : 0
Leap 59 : False
Leap 61 : False
Time Traceable : False
Frequency Traceable : False
PTP Timescale : False
Time source : Gps
Supported
Releases
10.5.1.0 or later
slave
Configures the IP address of PTP slave devices for the master clock.
Syntax
slave ip-address
Parameters ip-address—IP address of the slave clock device
Defaults No default IP address; unicast negotiation disabled
Command Mode INTERFACE CONFIGURATION - MASTER submode
Security and
Access
Netadmin and sysadmin
Usage
Information
You can configure the IP addresses of multiple slaves. The format of the slave IP address depends on the
configured unicast mode. The system reports an error when you configure more than the maximum
number of slaves. The no form of this command removes the configuration.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp transport ipv4 unicast master
OS10(conf-ethernet1/1/1-ptp-ipv4-master)# slave 10.10.10.1
OS10(conf-ethernet1/1/1-ptp-ipv4-master)# slave 10.10.10.2
Supported
Releases
10.5.1.0 or later
200 System management