Users Guide

ptp delay-req-min-interval
Configures the minimum interval between delay request messages.
Syntax
ptp delay-req-min-interval log2-seconds
Parameters log2-seconds—Configures the logarithmic time interval in seconds between successive delay request
messages. For the system default profile, enter a value from -7 to 5 (1/128 s to 32 s). For the ITU
G.8275.1 profile, enter a value from -7 to 4 (1/128 s to 16 s).
Defaults -4
Command Mode INTERFACE CONFIGURATION
Security and
Access
Netadmin and sysadmin
Usage
Information
This configuration is applicable only with end-to-end delay mechanism. The no form of this command
removes the configuration.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ptp delay-req-min-interval 1
Supported
Releases
10.5.1.0 or later
ptp domain
Configures the domain for the PTP clock.
Syntax
ptp domain domain-number
Parameters domain-number—Enter a value from the following ranges:
● System default profile: 0 to 127
● ITU G.8275.1 profile: 24 to 43
NOTE: Domain numbers 128 to 255 are reserved and cannot be configured for the system default
profile.
Defaults
● System default profile: 0
● ITU G.8275.1 profile: 24
Command Mode CONFIGURATION
Security and
Access
Netadmin and sysadmin
Usage
Information
The no form of this command removes the configuration.
Example
OS10(config)# ptp domain 1
Supported
Releases
10.5.1.0 or later
ptp enable
Enables PTP on a physical or port channel interface.
Syntax
ptp enable
Parameters None
Defaults Disabled
System management 189