Users Guide

Supported
Releases
10.2.0E or later
trust dot1p-map
Creates a user-defined trust map for dot1p flows.
Syntax
trust dot1p-map map-name
Parameters map-name — Enter the name of the dot1p trust map. A maximum of 32 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
If you enable trust, traffic obeys the dot1p map. default-dot1p-trust is a reserved trust-map name.
The no version of this command returns the value to the default.
Example
OS10(config)# trust dot1p-map map1
OS10(config-tmap-dot1p-map)# qos-group 4 dot1p 5
Supported
Releases
10.3.0E or later
trust dscp-map
Creates a user-defined trust map for DSCP flows.
Syntax
trust dscp-map map-name
Parameters map-name — Enter the name of the DSCP trust map. A maximum of 32 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
If you enable trust, traffic obeys this trust map. default-dscp-trust is a reserved trust-map name.
The no version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported
Releases
10.3.0E or later
trust-map
Configures trust map on an interface or on a system QoS.
Syntax
trust—map {dot1p | dscp} {default | trust-map-name}
Parameters
● dot1p — Apply dot1p trust map.
● dscp — Apply dscp trust map.
● default — Apply default dot1p or dscp trust map.
● trust-map-name — Enter the name of trust map.
Default Disabled
Command Mode
INTERFACE
SYSTEM-QoS
Usage
Information
Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp]
[trust-map-name] command to view the current trust mapping. You must change the trust map only
1400 Quality of service