Users Guide

After you configure Deep Buffer mode, the system displays a warning stating that the configuration takes effect only after
saving it in the startup configuration and reloading the switch.
NOTE: To disable Deep Buffer mode, use the no form of the command. Disabling Deep Buffer mode takes effect only
after saving it in the startup configuration and reloading the switch.
2. Save Deep Buffer mode in the startup configuration in EXEC mode.
write memory
3. Reload the switch in EXEC mode.
reload
Configure Deep Buffer mode
The configuration shows how to enable Deep Buffer mode in a switch.
OS10# configure terminal
OS10(config)# hardware deep-buffer-mode
% Warning: Deep buffer mode configuration will be applied only after a save and reload.
OS10(config)# exit
OS10# write memory
OS10# reload
Proceed to reboot the system? [confirm yes/no]: Y
To view Deep Buffer mode status, use the show hardware deep-buffer-mode command. The show command output
displays the status of Deep Buffer mode in the current boot and the next boot.
The following is Deep Buffer mode status before enabling it, the default setting:
OS10# show hardware deep-buffer-mode
Deep Buffer Mode Configuration Status
-------------------------------------------
Current-boot Settings : Disabled
Next-boot Settings : Disabled
The following is Deep Buffer mode status after saving the configuration in the startup configuration:
OS10# show hardware deep-buffer-mode
Deep Buffer Mode Configuration Status
-------------------------------------------
Current-boot Settings : Disabled
Next-boot Settings : Enabled
The following is Deep Buffer mode status after the switch reloads:
OS10# show hardware deep-buffer-mode
Deep Buffer Mode Configuration Status
-------------------------------------------
Current-boot Settings : Enabled
Next-boot Settings : Enabled
Congestion avoidance
Congestion avoidance anticipates and takes necessary actions to avoid congestion. The following mechanisms avoid congestion:
● Tail drop—Packets are buffered at traffic queues. When the buffers are exhausted or reach the configured threshold,
excess packets drop. By default, OS10 uses tail drop for congestion avoidance.
● Random early detection (RED)—In tail drop, different flows are not considered in buffer utilization. When multiple hosts
start retransmission, tail drop causes TCP global re-synchronization. Instead of waiting for the queue to get filled up
completely, RED starts dropping excess packets with a certain drop-probability when the average queue length exceeds the
Quality of service
1337