Reference Guide

This product is protected by U.S. and international copyright and
intellectual property laws. Dell EMC and the Dell EMC logo are
trademarks of Dell Inc. in the United States and/or other
jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
linuxadmin@OS10:~$
To log in to OS10 and access the command-line interface, enter su — admin at the Linux shell prompt, then admin as the password.
linuxadmin@OS10:~$ su - admin
Password: admin
OS10#
Frequently asked questions
This section contains answers to frequently asked questions for ONIE-enabled devices.
• Installation contains information about how to enter ONIE: Install mode after a reboot, nd information about your specic switch, how
to log into the OS10 shell, and so on.
• Hardware contains information about how to view default console settings, how to view hardware alarms and events, how to view LED
status, and so on.
• Conguration contains information about how to enter CONFIGURATION mode, how to modify the candidate conguration, and so on.
• Security contains information about how to add users, troubleshoot RADIUS, how to view current DHCP information, and so on.
• Layer 2 contains information about how to congure routing information including 802.1X, LACP, LLDP, MAC, and so on.
• Layer 3 contains information about how to troubleshoot BCP, ECMP, OSPF, and so on.
• System management contains information about how to view current interface conguration information, how to view a list of all
system devices, how to view the software version, and so on.
• Quality of service contains information about quality of service including classication and marking, congestion management, policing
and shaping, and so on.
• Monitoring contains information about how to view alarms, events, logs, and so on.
Installation
How do I congure a default management route?
Although the default management route was congured during installation, you can use the route add default gw command from
the Linux shell to congure the default management IP address for routing. SupportAssist requires the default management route is
congured to work properly, as well as DNS congured and a route to a proxy server (see Congure SupportAssist and proxy-server).
How do I log into the OS10 shell as the system administration?
Use linuxadmin as the username and password to enter OS10 at root level.
Where can I nd additional installation information for my specic device?
See the Getting Started Guide shipped with your device or the platform-specic Installation Guide on the Dell Support page (see dell.com/
support).
Hardware
What are the default console settings for ON-Series devices?
• Set the data rate to 115200 baud
• Set the data format to 8 bits, stop bits to 1, and no parity
706
Troubleshoot OS10