Reference Guide

Parameters map-name — Enter the name of the dscp trust map (up to 32 characters).
Default Not congured
Command Mode CONFIGURATION
Usage Information default-dscp-trust is a reserved trust-map name. If trust is enabled, trac obeys this trust map. The no
version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported Releases 10.3.0E or later
qos-map trac-class
Creates user-dened trust map for queue mapping.
Syntax
qos-map traffic-class map-name
Parameters map-name — Enter the name of the queue trust map (up to 32 characters).
Default Not congured
Command Mode CONFIGURATION
Usage Information The trac class will route all trac to the mapped queue if applied on the interface- or system-level. The no
version of this command returns the value to the default.
Example
OS10(config)# qos-map traffic-class queue-map1
OS10(config-qos-map)# queue 1 qos-group 5
OS10(config-qos-map)# queue 2 qos-group 6
OS10(config-qos-map)# queue 3 qos-group 7
OS10(config-qos-map)#
Supported Releases 10.3.0E or later
trust-map
Applies a dot1p or dscp trac class to a queue trust map.
Syntax
trust {dot1p | dscp} trust-map-name
Parameters
• dot1p— Applies a dot1p trust map.
• dscp—Applies a dscp trust map.
Default Disabled
Command Mode
SYSTEM-QOS
INTERFACE
Usage Information Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [string]
command to view the current trust mapping. You should change the trust map only during no trac ow, and
verify the correct policy maps are applied. The no version of this command returns the value to the default.
598 Quality of service