Administrator Guide

Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet.
Defaults No RIP network is congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces congured with any address the network command species.
oset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
S3048–ON
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an oset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prex-list-name Enter the name of an established Prex list to determine which incoming routes are
modied.
oset Enter a number from zero (0) to 16 to be applied to the incoming route metric matching
the access list specied. If you set an oset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
Routing Information Protocol (RIP) 1319