Administrator Guide

To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router with which to exchange
information.
Defaults Not congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
When a neighbor router is identied, unicast data exchanges occur. Multiple neighbor routers are possible.
To ensure that only specic interfaces are receiving and sending data, use the passive-interface command
with the neighbor command.
Related Commands
• passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specied network. To enable RIP on all networks connected to the switch, use this command.
S3048–ON
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
1318 Routing Information Protocol (RIP)