Reference Guide

Usage
Information
Use this command to minimize the time required to synchronize the default MAC address of the VLT
domain on both peer devices when one peer switch reboots. If you do not configure a VLT MAC address,
the MAC address of the primary peer is used as the VLT MAC address across all peers. This configuration
must be symmetrical in all the peer switches to avoid any unpredictable behavior. For example, unit down
or VLTi reset. The no version of this command disables the VLT MAC address configuration.
NOTE: Configure the VLT MAC address as symmetrical in all the VLT peer switches to avoid any
unpredictable behavior when any unit is down or when VLTi is reset.
Example
OS10(conf-vlt-1)# vlt-mac 00:00:00:00:00:02
Supported
Releases
10.2.0E or later
vrrp mode active-active
Enables the VRRP peers to locally forward L3 traffic in a VLAN interface.
Syntax
vrrp mode active-active
Parameters None
Default Enabled
Command Mode VLAN INTERFACE
Usage
Information
The no version of this command disables the configuration. This command is applicable only for VLAN
interfaces.
Example
OS10(conf-if-vl-10)# vrrp mode active-active
Supported
Releases
10.2.0E or later
704 Virtual Link Trunking