Reference Guide

NOTE: In S5148F-ON, when receive is turned on, it enables decoding of both LLFC and PFC
frames on that port.
● transmit — (Optional) Indicates the local port can send flow control packets to a remote device.
● on — (Optional) When used with receive, allows the local port to receive flow control traffic. When
used with transmit, allows the local port to send flow control traffic to the remote device.
● off — (Optional) When used with receive, disables the remote device from sending flow control
traffic to the local port. When used with transmit, disables the local port from sending flow control
traffic to the remote device.
Default Disabled (off)
Command Mode INTERFACE
Usage
Information
The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# flowcontrol transmit on
Supported
Releases
10.3.0E or later
match
Configures match criteria for the QoS policy.
Syntax
match {cos cos-number | ip [access-group name name | dscp dscp-value |
precedence value] | ipv6 [access-group name name [set dscp dscp-value]] |
mac access-group acl-name | not [ip | cos] vlan vlan-id} [set dscp dscp-
value]
Parameters
● cos cos—number — Enter a queue number for the CoS match criteria (0 to 7).
● ip — Enter the IPv4 match criteria.
● access-group name name — (Optional) Enter the IPv4 access-group name.
● dscp dscp-value — (Optional) Enter a DSCP value for Layer 3 DSCP match criteria (0 to 63).
● precedence value — (Optional) Enter a precedence value for Layer 3 precedence match criteria
(0 to 7).
● ipv6 — Enter the IPv6 match criteria.
● access-group name name — (Optional) Enter the IPv6 access-group name.
● set dscp dscp-value — (Optional) Configure a DSCP value for Layer 3 DSCP match criteria (0
to 63).
● mac access-group name name — Enter an access-group name for the MAC access-list match
criteria (up to 140 characters).
● set dscp dscp-value — Enter a DSCP value for marking the DSCP packets (0 to 63).
● not — Enter the IP or CoS to negate the match criteria.
● vlan vlan-id — Enter a VLAN number for VLAN match criteria (1 to 4093).
Default Not configured
Command Mode CLASS-MAP
Usage
Information
In a match-any class, you can enter multiple match criteria. In a match-all class, if the match case is
access-group, no other match criteria is allowed. If you attach the access-list to class-map type
control—plane, the access-list ignores the permit and deny keywords.
Example
OS10(conf-cmap-qos)# match ip access-group name ag1
OS10(config-cmap-qos)# match ipv6 access-group name ACLv6 set dscp 40
Supported
Releases
10.2.0E or later
650 Quality of service