Reference Guide

Command Mode IPV4-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Example
OS10(config)# ip access-list egress
OS10(conf-ipv4-acl)# seq 5 permit udp any any capture session 1 count
Supported Releases 10.2.0E or later
seq permit udp (IPv6)
Assigns a sequence number to allow UDP IPv6 packets while creating a lter.
Syntax
seq sequence-number permit udp [A::B | A::B/x | any | host ipv6-address [eq]]
[A::B | A:B/x | any | host ipv6-address [eq]] [ack | fin | psh | rst | syn |
urg] [capture | count [byte] | dscp value | fragment]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number (0 to 4294967295).
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Set all routes which are subject to the lter:
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values (0 to 63).
• fragment — (Optional) Use ACLs to control packet fragments.
• eq — (Optional) Permit packets which are equal to.
• ack — (Optional) Set the bit as acknowledgement.
• fin — (Optional) Set the bit as nish (no more data from sender).
• psh — (Optional) Set the bit as push.
• rst — (Optional) Set the bit as reset.
• syn — (Optional) Set the bit as synchronize.
• urg — (Optional) Set the bit set as urgent.
• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes — when you enter the count byte options, only bytes increment.
Use the no version of this command to remove the lter, or use the no seq sequence-number command if
you know the lter’s sequence number.
Example
OS10(config)# ipv6 access-list egress
OS10(conf-ipv6-acl)# seq 5 permit udp any any capture session 1 count
Supported Releases 10.2.0E or later
428 Access Control Lists