Reference Guide

lldp tlv-select dcbxp-appln iscsi
Enables a port to advertise iSCSI application TLVs to DCBX peers.
Syntax
lldp tlv-select dcbxp-appln iscsi
Parameter None
Default iSCSI application TLVs are advertised to DCBX peers.
Command Mode INTERFACE
Usage Information DCB devices use DCBX to exchange iSCSI conguration information with peers and self-congure. iSCSI
parameters are exchanged in time, length, and value (TLV) messages. DCBX requires LLDP enabled to advertise
iSCSI application TLVs. iSCSI application TLVs advertise the PFC dot1p priority-bitmap congured with the iscsi
priority-bits command to DCBX peers. If you do not congure an iSCSI dot1p-bitmap value, iSCSI
application TLVs advertise dot1p 4 by default only if you congure dot1p 4 as a PFC priority with the
pfc-cos
command. The no version of this command disables iSCSI TLV transmission.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp-appln iscsi
Supported Releases 10.3.0E or later
show iscsi
Displays currently congured iSCSI settings.
Syntax
show iscsi
Parameters None
Command Mode EXEC
Usage Information This command output displays global iSCSI conguration settings. Use the show iscsi session command to
view target and initiator information.
Example
OS10# show iscsi
iSCSI Auto configuration is Enabled
iSCSI session monitoring is Enabled
iSCSI COS qos-group 4 remark dot1p 4
Session aging time 15
Maximum number of connections is 256
Port IP Address
------------------------
3260
860
3261 10.1.1.1
Supported Releases 10.3.0E or later
show iscsi session
Displays information about active iSCSI sessions.
Syntax
show iscsi session [detailed]
Parameter detailed — Displays a detailed version of the active iSCSI sessions.
Converged data center services 565