Users Guide

enable dom traps
Enables DOM traps if the specied parameter crosses the dened threshold three times.
Syntax
snmp-server enable traps dom {temperature | voltage | rx-power | tx-power |
bias}
Parameters temperature | voltage | rx-power | tx-power | bias — Enter the keyword to enable DOM
traps for the specied category.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command disables the DOM traps.
Example
OS10# configure terminal
OS10(config)# snmp-server enable traps dom temperature
OS10# configure terminal
OS10(config)# no snmp-server enable traps dom temperature
Supported Releases 10.4.3.0 or later
feature auto-breakout
Enables front-panel Ethernet ports to automatically detect SFP media and autocongure breakout interfaces.
Syntax
feature auto-breakout
Parameters None
Default Not congured
Command mode CONFIGURATION
Usage information After you enter the feature auto-breakout command and plug a supported breakout cable in a QSFP+ or
QSFP28 port, the port autocongures breakout interfaces for media type and speed.
Use the interface breakout command to manually congure breakout interfaces. The media type plugged
into a port is no longer automatically learned. The
no version of this command disables the auto-breakout feature.
Example
OS10(config)# feature auto-breakout
Supported releases 10.4.0E(R1) or later
fec
Congures Forward Error Correction on 25G, 50G, and 100G interfaces.
Syntax
fec {CL74-FC | CL91-RS | CL108-RS | off}
Parameters
• CL74-FC — Supports 25G and 50G
• CL91-RS — Supports 100G
• CL108-RS — Supports 25G and 50G
Interfaces 245