Setup Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

721

722

723

724

725

726

727

728

729

730

INTERFACE mode

ip rip send version [1] [2]

Examples of the RIP Process

To see whether the version command is congured, use the show config command in ROUTER RIP mode.

The following example shows the RIP conguration after the ROUTER RIP mode version command is set to RIPv2. When you set the

ROUTER RIP mode version command, the interface () participating in the RIP process is also set to send and receive RIPv2 (shown

in bold).

To view the routing protocols conguration, use the show ip protocols command in EXEC mode.

DellEMC#show ip protocols

Routing Protocols is RIP

Sending updates every 30 seconds, next due in 23

Invalid after 180 seconds, hold down 180, flushed after 240

Output delay 8 milliseconds between packets

Automatic network summarization is in effect

Outgoing filter for all interfaces is

Incoming filter for all interfaces is

Default redistribution metric is 1

Default version control:

receive version 2, send version 2

Interface Recv Send

GigabitEthernet 1/1 2 2

Routing for Networks:

10.0.0.0

Routing Information Sources:

Gateway Distance Last Update

Distance: (default is 120)

DellEMC#

To congure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for sending

both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.

DellEMC(conf-if)#ip rip send version 1 2

DellEMC(conf-if)#ip rip receive version 2

The following example of the show ip protocols command conrms that both versions are sent out that interface. This interface no

longer sends and receives the same RIP versions as Dell EMC Networking OS does globally (shown in bold).