Setup Guide

Console Access

The device has one RJ-45/RS-232 console port, an out-of-band (OOB) Ethernet port, and a micro USB-B console port.

Serial Console

The RJ-45/RS-232 console port is labeled on the upper right-hand side, as you face the I/O side of the chassis.

Figure 1. RJ-45 Console Port

Accessing the Console Port

To access the console port, follow these steps:

For the console port pinout, refer to Accessing the RJ-45 Console Port with a DB-9 Adapter.

1 Install an RJ-45 copper cable into the console port. Use a rollover (crossover) cable to connect the console port to a terminal server.

2 Connect the other end of the cable to the DTE terminal server.

3 Terminal settings on the console port cannot be changed in the software and are set as follows:

• 115200 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No ow control

Pin Assignments

You can connect to the console using a RJ-45 to RJ-45 rollover cable and a RJ-45 to DB-9 female DTE adapter to a terminal server (for

example, a PC).

The pin assignments between the console and a DTE terminal server are as follows:

Getting Started