Service Manual

Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related Commands
ip access-list extended — creates an extended ACL.
permit — assigns a permit lter for IP packets.
permit tcp — assigns a permit lter for TCP packets.
resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name StartingSeqNum Step-
to-Increment}
Parameters
ipv4 | mac Enter the keyword ipv4or mac to identify the access list type to resequence.
access-list-name Enter the name of a congured IP access list, up to 140 characters.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to
4294967290.
Step-to-Increment Enter the step to increment the sequence number. The range is from 1 to
4294967290.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
220
Access Control Lists (ACL)