Administrator Guide

Layer 2 Switching Commands 396
Syntax
interface range {interface-range-specifier | interface-type all}
• port-range—A list of valid ports to configure. Separate non-consecutive
ports with a comma and no spaces; use a hyphen to designate a range of
ports. For more detailed information, see Command line parameters are
entered by the user to choose an individual value or range of values for the
specific command. Command line parameters are not syntax or range
checked until the carriage return is entered. In some cases, the user may
need to enter special characters, most often in a string parameter such as a
password or a label. Special characters are one of the following characters
(`! $ % ^ & * ( ) _ - + = { [ } ] : ; @ ' " ~ # | \ < , > . / ) or a blank. In
these cases, it may be necessary to enclose the entire string in double or
single quotes for the command line parser to properly interpret the
parameter.. The command line buffer parses up to the maximum number
of command line characters possible in the port-range parameter.
• port-type—Shows all interfaces of the specified type.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration, Interface Range and Interface modes
User Guidelines
Commands under the interface range context are executed independently on
each active interface in the range. If the command returns an error on one of
the active interfaces, it does not stop executing commands on other active
interfaces.
If a range of interfaces is specified using the dash notation, the beginning
range number (to the left of the hyphen) must be less than or equal to the
last number (to the right of the hyphen).