Administrator Guide

Switch Management Commands 1884
Command Mode
Global Configuration
User Guidelines
The source interface must have an assigned IP address (either manually or via
another method such as DHCP). This command is not supported on Dell
EMC N1100-ON switches. Dell EMC N1100-ON switches support
configuration of a single IP address in interface vlan configuration mode.
That IP address is used as the source interface address for this function.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#sntp source-interface vlan 1
sntp trusted-key
Use the sntp trusted-key command in Global Configuration mode to
authenticate the identity of a system to which Simple Network Time Protocol
(SNTP) will synchronize. To disable authentication of the identity of the
system, use the no form of this command.
Syntax
sntp trusted-key key-number
no sntp trusted-key key-number
• key-number — Key number of authentication key to be trusted. (Range:
1–4294967295)
Default Configuration
No keys are trusted.