Administrator Guide

Layer 3 Routing Commands 1768
ipv6 ospf transmit-delay
Use the ipv6 ospf transmit-delay command in Interface Configuration mode
to set the OSPF Transmit Delay for the specified interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
• seconds — OSPF transmit delay for the specified interface. In addition, it
sets the estimated number of seconds it takes to transmit a link state
update packet over this interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for
VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf transmit-delay 100
ipv6 router ospf
Use the ipv6 router ospf command in Global Configuration mode to enable
OSPFv3 and enter Router OSPFv3 Configuration mode. Use the no form of
the command to disable OSPFv3 and remove the OSPFv3 interface and
global configuration.
Syntax
ipv6 router ospf