Administrator Guide

Layer 3 Routing Commands 1761
Syntax
ipv6 ospf
no ipv6 ospf
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF on VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf
ipv6 ospf area
Use the ipv6 ospf area areaid command in Interface Configuration mode to
set the OSPF area to which the specified router interface belongs.
Syntax
ipv6 ospf area areaid
no ipv6 ospf area areaid
• areaid — Is a 32-bit integer, formatted as a 4-digit dotted-decimal number
or a decimal value. It uniquely identifies the area to which the interface
connects. Assigning an area id which does not exist on an interface causes
the area to be created with default values. (Range: 0-4294967295).
Default Configuration
This command has no default configuration.