Administrator Guide

Layer 3 Routing Commands 1545
ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member
query interval for the MLD interface, which is the value of the maximum
response time parameter in the group-specific queries sent out of this
interface. Use the “no” form of this command to set the last member query
interval to the default.
Syntax
ipv6 mld last-member-query-interval last-member-query-interval
no ipv6 mld last-member-query-interval
• last-member-query-interval — The last member query interval (Range: 0–
65535 milliseconds).
Default Configuration
The default last member query interval is 1 second.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-interval 5000
ipv6 mld host-proxy
This command enables MLD and MLD Proxy on the specified interface.
PIM and DVMRP are not compatible with MLD proxy. Disable PIM/DVMRP
before enabling MLD proxy.
Multicast routing must be enabled for the MLD proxy service to become
operationally enabled
Also, ensure that there are no other multicast routing protocols enabled on
the router and that IP multicast routing is globally enabled. Use the “no”
form of this command to disable MLD Proxy globally.