Administrator Guide

Layer 3 Routing Commands 1262
• ipv4-address—Only reset the adjacency with a single specified peer with a
given IPv4 peer address.
• ipv6-address [ interface interface-id ]—Only reset the adjacency with a
single specified peer with a given IPv6 peer address. If the interface-id is
given, only reset the adjacency on the specified interface. The interface id
must be a routing interface (a routed VLAN identifier). An adjacency that
is formed with the autodetect feature cannot be reset with the command.
• listen range – Reset all adjacencies that are included in the listen subnet
range.
• soft—BGP resends all updates to the neighbors and reprocesses updates
from the neighbors.
• in | out—If the in keyword is given, updates from the neighbor are
reprocessed. If the out keyword is given, updates are resent to the neighbor.
If neither keyword is given, updates are reprocessed in both directions.
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
Soft inbound reset causes BGP to send a Route Refresh request to each
neighbor being reset. If a neighbor does not support the Route Refresh
capability, the updated policy is applied to routes previously received from the
neighbor.
When a change is made to an outbound policy, BGP schedules an outbound
soft reset to update neighbors according to the new policy.
This command applies to routes for all address families.
When clear ip bgp is issued for any peers, any pending policy configuration
changes are applied, for all global policy and for all peers.
Command History
Introduced in version 6.2.0.1 firmware. Updated in version 6.3.0.1 firmware.