Administrator Guide

Layer 3 Routing Commands 1213

Layer 3 Routing Commands

The sections that follow describe commands that conform to the OSI model’s

Network Layer (Layer 3). Layer 3 Routing commands enable routing

protocols to perform a series of exchanges over various data links to route data

between any two nodes in a network. These commands define the addressing

and routing structure of the Internet.

The Dell EMC N1100-ON Series switches do not support routing.

This section of the document contains the following Layer 3 topics:

ARP Commands Loopback Interface Commands

Bidirectional Forwarding Detection

Commands

IP Multicast Commands

Border Gateway Protocol Commands IPv6 Multicast Commands

BGP Routing Policy OSPF Commands

DVMRP Commands OSPFv3 Commands

IGMP Commands Router Discovery Protocol Commands

IGMP Commands Routing Information Protocol Commands

IGMP Proxy Commands Tunnel Interface Commands

IP Helper/DHCP Relay Commands Virtual Router Commands

IP Routing Commands Virtual Router Redundancy Protocol

Commands

IPv6 Routing Commands

–