Setup Guide

The out-of-band (OOB) management switch is connected through the 1 GbE management port on each of the appliance base
enclosure nodes.
Table 11. Steps to connect to the base enclosure nodes to the OOB management switch
1 Connect the management 1GbE port of the bottom node (A) to port 2 of the OOB management switch.
2 Connect the management 1GbE port of the top node (B) to port 53 of the OOB management switch.
Cable the OOB switch to the management uplink
The OOB management switch must also be cabled to the management uplink.
Figure 13. OOB management switch connection to management uplink
Table 12. Steps to connect to the OOB management switch to the management uplink
1 Connect OOB management switch port 25 to the Management Uplink A.
2 Connect OOB management switch port 26 to the Management Uplink B.
NOTE: Work with your network administrator to determine the uplink ports to which the OOB management switch will
connect.
Configuring Dell PowerSwitch Series for Block-optimized (FC-only) deployments 31