Users Guide
Table Of Contents
- Dell EMC PowerStore Power Down and Reboot Procedures Guide
- Contents
- Additional Resources
- Introduction
- Power control procedures
- Powering off procedures for PowerStore node
- Powering on procedures for PowerStore node
- Rebooting procedures for a PowerStore node
- Powering off procedures for PowerStore appliances
- Powering on procedures for PowerStore appliances
- Powering off procedures for PowerStore cluster
- Powering on procedures for PowerStore cluster
- Safety precautions for handling replaceable units
- Support Notifications
condensation. Refer to Hardware acclimation times on page 20 to ensure the replaceable unit has thermally stabilized to
the operating environment.
NOTE: Your storage system is designed to be powered on continuously. Most components are hot swappable; that is, you
can replace or install these components while the storage system is running. However, the system requires that front bezels
should always be attached to ensure EMI compliance. Make sure you reattach the bezel after replacing a component. Also,
each slot should contain a component or filler panel to ensure proper air flow throughout the system.
Unpacking a part
Use these best practices to unpack a part.
Steps
1. Wear ESD gloves or attach an ESD wristband to your wrist and the enclosure in which you are installing the part.
2. Unpack the part and place it on a static-free surface.
3. If the part is a replacement for a faulted part, save the packing material to return the faulted part.
Safety precautions for handling replaceable units 21