CLI Guide

Table Of Contents
testrsyslogconnection
Table 110. Details of testrsyslogconnection
Description Allows you to check the connection with the rsyslog server.
Synopsis
racadm testrsyslogconnection IP address/domain name
Input
testrsyslogconnection IP address/domain name
Output A test connection to the rsyslog server was successful
Example To test rsyslog server connection:
racadm testrsyslogconnection 100.101.11.11
testtrap
Table 111. Details of testtrap
Description Tests the RACs SNMP trap alerting feature by sending a test trap from iDRAC to a specified destination
trap listener on the network.
To run this subcommand, you must have the Test Alert permission.
NOTE:
Before you run the testtrap subcommand, make sure that the specified index in the RACADM
iDRAC.SNMPAlert group is configured properly.
The indices of testtrap subcommand is co-related to the indices of iDRAC.SNMPAlert group.
Synopsis
racadm testtrap -i <index>
Input -i <index> Specifies the index of the trap configuration that must be used for the test. Valid values
are from 1 to 4.
Example
Enable the alert.
racadm set idrac.emailalert.1.CustomMsg 1
racadm set iDRAC.SNMPAlert.1.Enable 1
Set the destination email IP address.
racadm set iDRAC.SNMPAlert.1.Destination
192.168.0
View the current test trap settings.
racadm get iDRAC.SNMPAlert.<index>
where <index> is a number from 1 to 8
traceroute
Table 112. Details of traceroute
Description Traces network path of the routers as the packets traverse from the system to a destination IPv4 address.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
156 RACADM Subcommand Details