Owners Manual

4. Align the two retention hooks on the back wheel assembly unit with the two slots on the base of the chassis, and

insert the hooks into the slots.

5. Offset the back wheel assembly slightly to the back of the system and secure the unit in place using a single screw.

6. Align the two retention hooks on the front wheel assembly with the two slots on the base of the chassis, and insert

the hooks into the slots.

7. Offset the front wheel assembly slightly to the front and secure the unit in place using a screw.

8. Place the system upright on a sturdy, stable surface.

Removing The Wheel Assembly

1. Lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.

2. Remove the screw securing the front wheel assembly unit to the base of the chassis.

3. Offset the front wheel assembly unit slightly to the back of the system to release the retention hooks, and pull out

the front wheel assembly unit.

4. Remove the screw securing the back wheel assembly unit to the base of the chassis.

5. Offset the back wheel assembly unit slightly to the front of the system to release the retention hooks, and pull out

the back wheel assembly unit.

6. If you are not replacing the wheel assembly, install the system feet.

7. Place the system on a sturdy, stable surface and if applicable, rotate the system feet outward.

Figure 12. Removing and Installing the Wheel Assembly

slots on base of the tower (4) 2. wheel assembly unit (2)