Owners Manual

Figure 34. Removing a memory module
Next steps
1. Install a memory module.
2. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Installing a memory module
After working inside your system
Installing a memory module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
NOTE: The memory modules are hot to touch for some time after the system has been powered down. Allow the
memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the
components or metallic contacts on the memory module.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Locate the memory module sockets on the system board.
Steps
1. Push the ejectors on the memory module socket down and out to allow the memory module to be inserted into the socket.
CAUTION:
Handle each memory module only by the card edges, ensuring not to touch the middle of the memory
module or metallic contacts.
2. Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in
the socket.
NOTE:
The memory module socket has an alignment key that allows you to install the memory module in the socket
in only one way.
3. Press down on the memory module with your thumbs until the socket levers latch into a locked position.
When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on the other
sockets that have memory modules installed.
4. Repeat step 1 through step 3 of this procedure to install the remaining memory modules.
Installing and removing system components
69