Reference Guide

The detailed description for each command follows.
perccli /cx/vx show migrate
This command shows the progress of the virtual drive migrate operation in percentage.
Input example:
perccli /c0/v0 show migrate
perccli /cx/vx start migrate type=raidx [option=add|remove drives=[e:] s| [e:]s-x|
[e:]s-x,y] [Force]
This command starts the reconstruction on a virtual drive to the specified RAID level by adding or removing disks from the
existing virtual drive. You can use the following options with the start migrate command:
Table 17. Virtual drive migration command options
Options Value range Description
type=raidx
RAID [0|1|5|6|10]: The RAID level to which the virtual
drive must be migrated.
[option=add|remove
drives=[e:]s|
[e:]s-x|[e:]s-x,y]
[Force]
add: Adds the specified PD to the migrated raid level.
remove: Removes the specified PD from the migrated raid
level.
drives: Specifies the list of PD's which needs to be added
or removed.
force: If specified, then migration will start even if any drive
in the DG is secured by FDE.
Virtual drive migration can be done between the following RAID levels:
Table 18. Virtual drive migration table
Initial RAID level Migrated RAID level
RAID 0 RAID 0
RAID 0 RAID 1
RAID 0 RAID 5
RAID 0 RAID 6
RAID 1 RAID 0
RAID 1 RAID 5
RAID 1 RAID 6
RAID 5 RAID 0
RAID 5 RAID 5
RAID 5 RAID 6
RAID 6 RAID 0
RAID 6 RAID 5
RAID 6 RAID 6
RAID 10 RAID 10
Input example:
40
Working with the PERC Command Line Interface Tool