Manualshelf

Owners Manual

ManualsBrandsDell ManualsC SeriesPowerEdge R940xa
111112113114115116117118119120
Figure 100. Removing the MicroSD card
Next steps
1. Replace the MicroSD card.
Installing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the support bar.
4. Remove the air shrouds.
5. Remove the expansion card riser.
6. Remove the IDSDM or vFlash module.
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
Steps
1. Locate the MicroSD card connector on the IDSDM or vFlash module. Orient the MicroSD card appropriately and insert the
contact-pin end of the card into the slot.
NOTE:
Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards
during removal.
2. Press the card into the card slot to lock it into place.
Next steps
1. Replace the expansion card riser.
2. Replace the air shrouds.
3. Replace the support bar.
4. Follow the procedure listed in After working inside your system.
118
Installing and removing system components