Owners Manual

Figure 12. Installing the optional front bezel
a. front bezel
b. bezel lock
Related references
Safety instructions on page 60
System cover
The system cover protects the components inside the system and helps in maintaining air flow inside the system. Removing the
system cover activates the intrusion switch.
Removing the system cover
1. Follow the safety guidelines listed in the Safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
4. If installed, remove the front bezel.
1. Rotate the latch release lock counter clockwise to the unlocked position.
2. Lift the latch toward the back of the system.
The system cover slides back and the tabs on the system cover disengage from the slots on the chassis.
NOTE: The position of the latch may vary depending on the configuration of your system.
3. Hold the cover on both sides, and lift the cover away from the system.
Installing and removing system components
63