Setup Guide
Table Of Contents
- Dell™ Rack Installation Guide
- Guide d'installation du rack Dell™
- Table des matières
- Consignes de sécurité
- Instructions d'installation
- Marquage du rack
- Installation des assemblages à glissière RapidRails
- Installation des assemblages à glissière VersaRails
- Installation du système dans le rack
- Installation du chemin de câbles et du bras de gestion des câbles
- Acheminement des câbles
- Dell™ Rack- Installationshandbuch
- Dell ラック取り 付けガイド
- Guía de instalación del rack Dell™
12 Dell™ Rack Installation Guide
2
Place a mark approximately 7 inches above the original mark you made
(or count up 12 holes in a rack that meets EIA-310 standards) and mark
the rack’s front vertical rails with a felt-tipped pen or masking tape (if you
counted holes, place a mark just above the top hole). This mark or piece of
tape indicates where the system’s upper edge will be located on the vertical
rails (see Figure 1-4).
Figure 1-4. Marking the Vertical Rails
1 tape on vertical rail
1