Users Guide

Table 2. Status LED indicators (continued)
Icon Description Condition Corrective action
PCIe indicator The indicator turns solid amber if a
PCIe card experiences an error.
Restart the system. Update any required drivers for the
PCIe card. Reinstall the card. If the problem persists, see
the Getting help section.
NOTE: For more information about the
supported PCIe cards, see the Expansion card
installation guidelines section.
System health and system ID indicator codes
Figure 1. System health and system ID indicators
Table 3. System health and system ID indicator codes
System health and system ID indicator code Condition
Blue solid
Indicates that the system is turned on, system is healthy and system
ID mode is not active. Press the system health and system ID button
to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health
and system ID button to switch to system health mode.
Amber solid Indicates that the system is in fail-safe mode. If the problem persists,
see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System
Event Log or the LCD panel, if available on the bezel, for specific error
message. For information about the event and error messages
generated by the system firmware and agents that monitor system
components, see the Error Code Lookup page at qrl.dell.com
iDRAC Quick Sync 2 indicator codes
NOTE: iDRAC Quick Sync 2 module (optional) is located on the left control panel of your system.
Figure 2. iDRAC Quick Sync 2 indicators
Table 4. iDRAC Quick Sync 2 indicators
Wireless indicator code Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC
Quick Sync 2 button to turn on the iDRAC
Quick Sync 2 feature.
If the LED fails to turn on, reseat the left control
panel flex cable and check again. If the problem
persists, see the Getting help section.
White solid Indicates that iDRAC Quick Sync 2 is ready
to communicate. Press the iDRAC Quick
Sync 2 button to turn off.
If the LED fails to turn off, restart the system. If the
problem persists, see the Getting help section.
Diagnostic indicators 11