Owners Manual

NOTE: If the tape backup unit is being permanently removed, install a tape backup unit blank by sliding it into the
slot until it snaps into place.
NOTE: The procedure to install and remove the tape backup unit blank is similar to that of the tape backup unit.
NOTE: Tape backup unit blank must be installed in empty tape backup unit slot to maintain FCC certification of the
system. The blank also keeps dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 107. Removing and installing the tape backup unit
a. tape backup unit
b. tape backup unit slot
c. release tab
Related tasks
Before working inside your system
After working inside your system
Related reference
Safety instructions
Installing the tape backup unit
Prerequisites
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
Steps
1. Unpack and prepare the tape backup unit for installation.
For instructions, see the documentation that shipped with the drive.
2. If applicable, remove the tape backup unit blank by pressing the release tab and sliding the tape backup unit blank out of the chassis.
3. Slide the tape backup unit into the slot until it snaps into place.
4. Connect the power and data cables to the back of the drive and the system board.
166
Installing and removing system components