User guide

Installing Blade Components 149
Figure 3-28. Removing and Installing the Hard-Drive Backplane (PowerEdge M605
Shown)
5 To install the hard-drive backplane:
a Hold the backplane with the drive connectors facing towards the hard
drive bays.
b Position the backplane so that the retention hooks on the end of the
drive bay are aligned with the corresponding slots in the backplane.
c Press the backplane into place until the connector. is fully seated and
the latches at each end snap over the upper edge of the board.
6 Replace the hard drive(s).
If you are installing two drives, be sure and reinstall them in their original
locations.
1 hard-drive backplane 2 hard-drive connectors (2)
3 retention hooks (3) 4 latches (2)
5 backplane connector on system
board
1
3
2
5
4